1. The paving surface of the geogrid should be relatively flat. After the paving layer is qualified, in order to prevent longitudinal deflection, white lines or hanging lines should be drawn on the paving layer according to the width to start paving.

2. Fix the end of the grid with iron nails (8 nails per meter wide, evenly spaced). After fixing the end of the grid, use a paving machine to slowly pull and lay the grid forward. Manually tighten and straighten every 10 meters long until one roll of the grid is laid, and then lay the next roll. The operation is the same as before.

3. After laying one roll, use a 6T-10T roller to roll it in the forward direction from the starting point. (If it is laid on the middle surface layer and leveling layer, it is advisable to use a steel roller roller; if the grille is directly laid on the concrete pavement, it is advisable to use a rubber roller roller.)

4. Laying: The length of the section to be laid is measured by the length of the roll. After the section to be laid with the grid is filled, the paving is checked again, and then the next section is laid. When the next section is laid, the grid and grid can be overlapped with a length of 10-15CM and fixed with iron nails or wooden wedges before continuing to lay the second section in the forward direction. The operation requirements are the same as before.